Is anyone using Grow Ace AirCubes? I’m having an issue with overflow. The brain module is not telling the pump to turn off when the floats hit the top. It was an ongoing issue, it corrected itself about two weeks ago. Yesterday morning there was a tiny bit of over flow, cleaned it up, and it didn’t happen again till this morning, and there was a lot of overflow. I’ve checked for float movement, found one piece of tubing had a kink in it, so I replaced that piece.
I’ve emailed the company, but my email was rejected, said the mailbox was full. I’ve talked to them in the past about the issue and basically they were no help at all.
1 Like
I’ve been researching this system for a few months and sure you’ve seen the float adjustment for the 14” max…possibly this could be adjusted too high for the pots and could be adjusted down?? 
I thought of that, but when I did catch the cycle, the floats were totally underwater, and the only thing that stoped the pump was the float arm on the side of the bucket. By the time it gets to that float arm it’s too late for the AirCubes, already overflowing. I did adjust the floats down a little, but not sure that’s going to stop it.
1 Like
Hope it’s that simple Grow Bro. Seriously looking into the 6 pot set up
I have a 6 pot system and a 12 pot system. When they work they are great
1 Like
Well, I just barley bumped the floats down, maybe 1/8 inch, and it hasn’t flooded since. Doesn’t make any logical sense, as when it floods over, the floats are totally submerged. Hopefully the company will respond.
1 Like
Hopefully that works Grow Bro, standing by
It didn’t work, it will go 8 to 10 cycles without overflowing, then it does overflow. The company I has not responded in almost a week. I’m having a very hard time recommending this company to anyone.
1 Like
Now the second system in the scrog tent has a little overflow this morning. Very disappointed in this company.
1 Like
Hate to hear this Growmie and appreciate the update
1 Like