Stem rot vs bud rot

Hey all fellow growmies, I’ve run across something new for me and need your help and opinions. I’m unfortunately a little too familiar with bud rot, bugs, and caterpillar damage. But I have run across what looks like stem rot.

There were a couple of buds on the stems that looked like they were damaged as well, perhaps even by the stem rot. So those got cut off and tossed. But other buds look totally fine along the same stem. So, my question is if the bud looks OK, should I continue to trim, wash, dry, harvest, those buds and get rid of any visibly damaged buds or should I throw out everything on the rotted stem?

Thanks for your help on this. I’ve isolated the damaged stems away from everything else until I understand the best option.

@Oldguy @Low @Lostgirl @Retiredoldguy @T-ray @David1974 @DanB @plumbdand @Lightbrightt2010

13 Likes

I’d toss everything close and do a multiple step wash. See how it turns out in cure.

18 Likes

I’ve cut the stems about 3 inches below where I see the last trace of the stem rot. Happy to throw them if it’s bad.

9 Likes

Rot is rot. I agree with @Low , if it’s got rot on or around it get rid of it the rest do a good wash.

12 Likes

Wash is always part of it but I’d rather toss than wash if it’s not good.

10 Likes

Well rot spreads by spores and penetrates plant tissue. Spores travel everywhere, but if it didn’t make it through the plant tissue the bud should still be good. The wash should kill spores in the surface,

Any effected branches I’d toss. Wash others without visual problems well.

12 Likes

Toss anything that has visible mold and wash the rest. Im currently using 1st bucket hypochlorous acid and water fully submerge for at least a minute or two, shaking it vigorously before putting it in the 2nd bucket that has peroxide and water 3rd bucket just has water for rinse.

10 Likes

Really cool. Never heard that being used in a wash. I like it. Thanks for sharing.

10 Likes

@Darran Other folks all got you covered my friend.

Just had a couple spots on my GFOG.
HCL bath and drying now.

9 Likes

Some places use it to wash vegetables. It breaks down into salt and water. I only use when I have a lot of mold or bud rot.

9 Likes

You can pick up a generator and make your own fairly reasonably.

This is the one I have. Make it when I need.

:victory_hand::dashing_away::dashing_away:

Edit : That’s in :canada: $$$. :backhand_index_pointing_up: :wink:

8 Likes

I couldn’t remember who it was that made their own Thanks @Oldguy

9 Likes

More than welcome @plumbdand
There’s a few others that make their own as well just can’t recall who right off. Lol.
Damn CRS. :roll_eyes:
Might be some of the GFOG too. :joy:

:victory_hand::dashing_away::dashing_away:

10 Likes

Sup @Darran . I would inspect closely to ensure you eliminate any rot, which sounds like you have already done. If you have a “rot” problem in stems, that is something I have not personally experienced. All the moisture is in the flowers and growers in humid climates can expect to battle that threat and I can attest it happens. From the pictures you posted, I can’t say one way or another. Like @low and others have stated, eliminate anything with rot or mold. Best to you man.

8 Likes

Brain fog from the GFOG

10 Likes

Floraflex has a root wash that is basically hypochlorous acid :nerd_face:

9 Likes

morning Darran… good advice given already… when I find it at harvest time it has just started and I throw away that branch and closely inspect all branches and buds once I find a spot of mold… I have never done a wash mostly since I am inside and just prefer to toss the affected branches…so far this has worked for me but the rot that I have gotten was fairly light and couldn’t tell I had it till I tried to break open the big bud which I do on every bud to make sure nothing inside… I have never gotten it so bad as to see the brown decaying plant just the white fuzz…

7 Likes