Checked on ladies today and didnt look right to me. My temps are in the low 20 c and im 54 days from 12 12 flip and its a 50 to 55 day strain. I have co2 bags and i dont think i have any environmental stresses other than low humidity. Ive never had this problem before and allways have low humidityUploading: 20210319_200514.jpg… Uploading: 20210319_200521.jpg… Uploading: 20210319_200611.jpg… Uploading: 20210319_200547.jpg… Uploading: 20210319_200530.jpg…
If pics dont upload i wull try again
You need to wait until it uploads photos 100% before posting
my phone is screwing up one sec more pics are coming
As long as it says “uploading” it won’t post the pictures. You need to wait until it says “uploaded”
Somthing isisnt working for me i waited and it said unable to send. Will these pics do i can see the issue im having in them
Im also sure i see some nanners that arent in these pics
Add a photo, WAIT until it is uploaded completely, hit enter twice to drop down to a new
text line and repeat the process until photos are loaded. You’re adding photos on top of each other and not allowing them to load fully before posting. That includes the very last photo, before you hit reply.
Hard to see in these pics also but they are foxtailing a lil bit im sure
I’m seeing slight possibilities of FoxTailing but of the photos you uploaded, two of them are yellow blobs that isn’t showing what problem you are asking for help with. Can’t see the “nanners” or round leaves but some FoxTailing is possible to see but very faint in the photos.
It’s kind of hard telling under the HPS lights, but it appears that you have a little foxtailing going on. New calyx are growing on top of old calyx. They will continue to do that as long as you allow it. The buds keep getting bigger, but the tops never mature, while the buds further in are done.
I’d give it a week or two then chop it down.
one has some nanners what should i do with that one. leave it or chop it
If you are comfortable that the trichomes in the middle of the bud are done to your satisfaction you can chop it.
im having tech difficulties my bad
I did have to move one plant from under hps to led quantum board. This is the one showing nanners. Could the light type change(same spectrum)cause nanners?