So many leaves have died. Still leaves in the buds. It is an auto at 11 1/2 weeks. Still think I will get flowers but don’t know where I went wrong. Any advice is appreciated…
Thanks
Is that on your tallest cola? Looks like a little bit of light burn maybe. I want to say it’s just eating itself, starting to finish up. But there’s still quite a few white, straight out pistils, telling me she’s still swelling. You should fill out a support ticket. With some more info, we can figure this out.
If you do not know, or do not use something; Just say so; Or post
NA (non applicable)
- What strain, Seed bank, or bag seed
- Method: Soil w/salt, Organic soil, Hydroponics, Aquaponics, KNF
- Vessels: Pots, Grow beds, Buckets, Troths
- PH of Water, Solution, runoff (if Applicable)
- PPM/TDS or EC of nutrient solution if applicable
- Indoor or Outdoor
- Light system
- Temps; Day, Night
- Humidity; Day, Night
- Ventilation system; Yes, No, Size
- AC, Humidifier, De-humidifier,
- Co2; Yes, No
2 Likes
This is my second grow. The first was outside in the sun with better results until the bud rot issue right at the end.( was able to save the harvest) It is too humid where I live outside. I am sure I will get a harvest here but something is not right and I would like to avoid it next time. I have a second plant in there that is an Auto Cheese. It is doing better but growing slower.
How high above the canopy is your light?
10 inches from the highest point on both plants. I can go about another 8 inches or so if it matters at this point. Please let me know.
Thanks for the help. Always appreciated…
Yes, I’d start raising them. The manufacturer recommends 18-24" here: https://www.amazon.com/VIVOSUN-Spectrum-Hydroponic-Growing-Flowering/dp/B077P386Y1
She should be fine though, and finish up nice.
How are the roots? Are they brown or white? Could be from over watering, they need less water as the end comes near, but I’m just guessing from a picture.
Thank You
I am guessing next time I will start with the light further and if I detect stretch I can go lower.
1 Like
I was told you can’t over water in Coco. Initially I suspected that as the leaf ends curled under. I did reuse this Coco. I won’t do that again.
2 Likes
Yep, I’d start at about 24", then gradually lower throughout the first few weeks of flowering, down to the lowest they can take without adverse reactions. Depends on the strain, I had my lights 8" from my canopy at the end of one…I’d have to go through my journal to remember which, but if they can take it, the lower the better. Something, something, inverse square, something something… 
You will see some leaves getting robbed and yellow towards the end of flower so this is not so unusual. The tips looked a bit burned from nutrients perhaps too.
Overall I think you’re looking ok.
I reused some Pro-Mix HP and had similar minor issues. I won’t be doing this again. I can’t say this was the problem, but will be starting fresh from here forward.