Question about mold and drying

So quick question about mold on harvested bud I harvested today and found some mold growing on some of my main colas never had a problem b4 .so I trimmed the bud up into smaller buds so I could make sure I got it all it’s in the drying rack temp is 76 degrees with fan blowing directly below blowing on bud . If I didn’t get all the mold will it keep spreading while drying and could it spread to the bud that was not infected i did put it on separate shelf from the good stuff

1 Like

Yes. The air from fans blowing around will spread the spores around

3 Likes

@Oldguy is it too late for the peroxide dip?

1 Like

@Konflict. @Tom1. If it hasn’t Dried for very long / just cut then I would def dip it in the peroxide bath.
I would remove and discard all mouldy buds.
Don’t aim the fan right at the buds afterward / I think you would want an indirect air flow.
If you can then shake off the excess water / peroxide / rinse water before hanging or laying on screen to dry.
Best of luck with this. :wink::+1::v:

3 Likes

Ok so I did the peroxide bath and is in the drying room on screen racks thanks I hope this works I estimate over a pound that was hard to do

1 Like