On your feed. Follow the instructions above with the Epson salt top dress.
Due to the epin salt, your numbers are likely going to come out pretty high on the runoff ppm. It’s okay for this one time you need that magnesium fix.
After this feed, so we can adjust whatever the PPM overages are on the following feed and will discuss how and when to use the overdrive.
For now, stick with the plan
You can make a 3-inch circle rather than a 4-inch circle around the stem as your do not cross line as your pots are kind of small
An is it possible it was sweat that dropped when I was in there the last feed time getting them all situated back out. I’m to the point I’m doing shuffles and putting them in different spots only when putting them back in during feed time. In and out can be a lot of work. Want to get my room built so I can make raised pot holders and just a metal grate under and have it drip under into a tray I can slide in and out.
That’s good, I’ve seen spider mites suckling the leaves and make those spots but they don’t come off. I would just clean them off (or not) and wouldn’t be too concerned.
If you have very hard tap water and use a humidifier in your tent sometimes the minerals in the water harden and will create a powder on the leaves.
You could have spelled something as well. I wouldn’t be concerned. Feel free to always look at the front and the back of your leaves when watering etc to examine for pest as you just never know. You can never be too vigilant!
We always try to think of ways to make things easier as it can be difficult.
I came up with this idea a couple years ago. I flipped (six pack case) Pepsi crates upside down and bought dollar store turkey pants they fit perfectly underneath and the drainage is fantastic my plants never sit on the ground and they never sit in water I simply pull out the tray and check my runoff dump it and I’m finished.
I checked as soon as I seen them a did a little research. That’s some relief news for sure. It’s only on the one plant I thought I felt sweat bead off me. I looked for it but couldn’t see it. Checked the other plants and they didn’t have them on them. I do use distilled in the humidifier. Prevent the white powder residue. I also got my humidity set down to 60% and put the fan on low to blow between the bottom of the plants and the top of the pot. I just made those changes this evening. I was running 70-75% humidity and got that checked back in. Day times 75f and nights 67f
Boom that’s absolutely perfect. awesome. I’ll be utilizing this or something similar that’s for sure. Can’t wait to get this room built. It will happen after this grow finishes. Maybe late summer/fall.
I even use them all through my garden outdoors as well. And the stores just throw them out back. You can ride behind any shopping center and pick them up all over the place
Been a long day yesterday and today but finally got the girls out of neglect. Been raining non stop and took me forever to get some grass mowed and didn’t have time to feed yesterday like I should have. Didn’t even see them yesterday. But got them takin care of thanks to @Lostgirl here are some numbers and curious if I should do some more chip tomorrow say under the line get that stuff gone?
As I told you the numbers would go very high as the Epsom salt tacs on a ton of ppms. However they definitely needed it and we can adjust them in the next feed.
I wouldn’t take anything else off unless it’s a very small unproductive Bud site. You’re already at the maximum height for lollipopping.
What you could do, is trying to open your plants branches like a blooming onion thistle supply more lightning to some of those hidden sites
I’m truly not a light person and I don’t chase ppfd numbers. I used to manufacture settings recommendation in heights and percentage and that’s it. There’s a lot of light guys will chime in
It’s fine that your numbers are that high nevertheless, we’re going to adjust your feed to put your numbers back on track where they actually should be. We gave the girls a lot of magnesium that I personally feel they needed badly. This is what I would do my next feed…
Recipe is milliliters per gallon
1 gallon Tap water
3ml Calmag
4ml Micro
4ml Grow
4ml bloom
2ml B-52
3ml Overdrive
3ml Bud Candy
That’s it.
Your number should come out a lot less with the above recipe to compensate for the large shot of magnesium that we did. Keep in mind we top dressed the magnesium so that we could get a little slower distribution of the magnesium yet still achieve its needs. What this means is your next feed with the above recipe could still throw out slightly higher than normal numbers but again it’s okay don’t worry about.
that’s absolutely perfect. 
awesome. I’ll be utilizing this or something similar that’s for sure. Can’t wait to get this room built. It will happen after this grow finishes. Maybe late summer/fall.
ton of ppms. However they definitely needed it and we can adjust them in the next feed.
thanks so much!!!
