Then I’ll keep them 18/6 don’t wanna stress them again and again ,
Anything regarding the tip , another one showing same .
@Covertgrower Even the PH is shooting from 5.8 to 7 in 24 hour
If you don’t have a reservoir you’ll have ph swings.
@Covertgrower Can you please give advice on the above picture , tip curling down
I’m little worried
Probably just got beat up from the transplant. I see new growth, it’s still doing okay.
@Covertgrower I was worried that may be I have over fed them with nutrients .
Will just adjust the ph and hope everything goes well.
Thank you for reply 
Got worried too much 
I see you have @Covertgrower helping out here… he knows far more than I do… And he grows autos successfully which in my opinion is a real feat … I have absolutely nothing but problems with auto flowers they are just not for me… I’m gonna stick around and watch how you do and maybe watching your journal I will be able to figure them out… @repins12 … Just got done with the giant DWC harvest… And he grows an auto flower or two in soil at the same time …
Will update you soon , and send pictures
Thank you
I didn’t take notice of your ppm and what it was at.
I usually feed my smallest sprouts Around 100 ppm and moving from 150-200ppm by the second node
@TDubWilly it was at around 350
( tap water -100 + nutes -200 Cal/mag-50)
I’m using advance nutrient ( micro , grow , bloom ) in a 3gallon container
Which of the three have the most nitrogen then only use that bottle for nutrients for the present time, don’t exceed 200ppm right now.
I looked through those bottles trying to find which had the most and couldn’t find it, shop that will be up to you but I’m willing to bet your N number on your cal mag is probably only 1.
In the grow or the micro I’m assuming you’ll find a considerable amount more N when you look up the NPK on it
I normally use general hydroponics micro and bloom only so it’s a bit of a crossover for me trying to figure out other nutrients online
@TDubWilly I’ll check and use one with max nitrogen
And adjust ppm around 200
Will keep you updated
Thanks in advance
@TDubWilly @Covertgrower @Happilyretired
Flushing this one with plain ph and
Then starting with low ppm
Any advice ?
Just keep those pebbles wet until your roots have a stronghold in that water
400ppm or less is good.
These guys got you covered…
@Covertgrower @TDubWilly @Happilyretired
After 24 hours
Ph -5.9
Ppm - 160
The new leaves are coming fine but the old one is getting worst
