I have used the Lobo with concentrates with the pads. Worked fine but difficult to keep clean. If I were going to use concentrates regularly I would look for a different solution.
The concentrate that I used was “wax” from my Torr Kitchen vacuum still.
Edit: I often sprinkle keif on the buds before loading. That works great!
Right on buddy 
Flower is my Power but a little dab here and there isn’t bad but I got a rig for that 
Putting concentrate directly into the oven (ie no capsule) would likely ruin your Lobo after using for a while.
At this point I don’t plan on using anything in the oven that’s not in the capsule 
Out for delivery
Looked around for my old 18650 bats and charger to have one hot and ready but no luck.
I’ll have to watch the paint dry 
Be careful with battery selection. Not all 18650 batteries are designed for high current draw.
Don’t forget to “burn” it in when you receive your vape. 
What Kap said…That is very important!
Yes sir 
One of my hobbies I deal with the explosive Li-Po 
I will 
…forget that is
morning vapers… just got back from an early morning ride on the lake… so nice with the capsules just pop one out and pop one in and let it be windy because I don’t need no stinking lighter to vape… just ride and glide… 
Was hoping that and way I ordered a extra pack and the caddy
@kaptain3d What is “burning it in”?
Initial “test run” to burn off BS from shipping and manufacturing
What @StonedCold13 said. You should do a couple of “test run” without any material in your vape to get rid of all the nasty stuff and weird taste a new vape has..
Haven’t read any instructions yet but I’ma assuuuume ya gotta do the same with each Dose Cap too
I didn’t on the capsules… just the main heating element chamber
I’ll at least hit them with some Carb Clean 
DD coming in hot
at highest temperature setting
While Ye here Sir Wiz.
What’s the session timer? Is that a must?
So it sits there and stays heated up for set amount of time ready to hit?