Well the plant looks good its self it just looks to be a lil hungry and do you use some form of calcium and magnesium cause its looking like they need a lil magnesium
Yes, using the dyna gro regime. Silica, bloom, and mag pro. I follow the feed ing measurements scared of nute burn. Should I be trimming fan leaves for better lighting for the lower spots?
I was also considering upping the doses since I’ll be flushing in a couple of weeks.
Ok do your nutes have calcium thats what it look like it’s needing
It says they do. Not sure if I need an additive. What are the signs of calcium deficiency
Give me a min im going to go see if i can find my chart but how far along are you in flower it could just be your plants eating itself something is pose to do at the end of flower
At this stage they need alot of p.k of n.p.k chart
Alot more then p and k this is when they like the odd ball items … terp cannabinoid production resin production are all complex processes they need alot more then nitrogen phosphorus and potassium
I’m in week 5 from flip. My regular watering consist of hydraguard, pro silica, bloom, and mag pro. The latter 3 all from dyna gro. I thought the plant wash just drawing off itself. I will say though I thought my TDS meter was off because it was showing a 400 ppm average passed on there feeding schedule. I oft thought about increasing it, but in the FF Coco Loco wasnt sure if all the nutes in that had been used.
Are you phing your nute mix ?
Yes, 6.3 to 6.6 range
Do you use silica every watering? Only reason I say because silica shoots ph way up and if aren’t adjusting after you let nutes fully dissolve your ph will continue to fluctuate until ur fully dissolved and silica is thick and should be bubbled for a lil while or if you mix in a gallon jug put your nutes in shake the hell out of it for a lil bit … let sit for a minute then check ph check adjust when you adjust shake or bubble again for a couple mins check and then pour or adjust more if needed… slot of ppl dont fully dissolve there nutes. Unknowingly
Yes use silica every watering. I normally let it sit a minimal 1 hour to settle before adding anything. An from there I give the hydraguard a hour, bloom, and mag pro follow. An I usually let it sit over night to make sure the ph is stable before feeding. One thing I have learned is you cany have to many meters.
I will also add, that I also started adding increments of the nutes to balance vs. Up and Down. I figured why balance with something that is not useful for the plant. An it is always distilled water so my routine is pretty consistent.