Hydroponic initial Solution

These are Blue Dream femmes, do you think they are too big to transplant?

With the low cost of RO filter it sure helps and only what you put in the water is what your working with.

Ok basic setup follow-up question:
Besides the hydroguard, What do I add to the water? I have the following Fox Farm liquids:
Big Bloom
Grow Big
Tiger Bloom
Cal-Mag
Bembi
Let me Kelp You
Holy Mackerel
MicroBrew
KangaRoots
Boomerang

I have pH up and hydroguard on the way but I don’t know where to begin.

Thanks.

Same. I’m doing a redesign on my system as i learned a huge amount from my first grow.

This is what i use in my RDWC with great results. I’m averaging 10 ounces per plant my last grow.

ILGM Autos
General hydroponics trio
Silica
Calmag
Home made beneficial bacteria tea made from: molasses, Southern AG, and mitochondria.

I’m keeping it simple and cheap.

morning @SmittyJ …I am not familiar with those nutrients…Cal-Mag if you are using RO or distilled water…if you are using tap water it is not needed …I am going to suggest to keep it to the basic NPK nutrients. and half the manufacturer recommendation…most of the extras are not needed for most grows…you need some kind of silica Si for stem strength because of the fast growth…

I would recommend these only plus a root inoculant. Great advice from @Retiredoldguy :love_you_gesture:

What medium are you using in your DWC net pots?
I don’t see a reservoir to recirculate your nutrient rich water. I do see an air pump to supply air to roots.

Distilled water is a great option but it seem your tap water at 100 ppm is a perfect option. My tap water is a bit over 200 ppm and works fine when my catchment system runs dry. Rain water is what I mostly use. I’ve added a 20 gallon cistern and a few well placed buckets in my backyard.


I’ve been using GH Flora Series for a long time. I try to adhere to above feed chart.
For Hydroguard I use it each time I add water at at 1ml per gallon.
Keep water temp around 68F When you add to your bucket. Make sure to get them plenty of fresh air and keep temps below 85F and above 65F.

Hey LateNightGardner and thanks for the reply. I am using the clay pebbles for the top tray medium. My setup doesn’t have a reservoir, it uses air to create suction in the individual buckets in order to top feed so its really not a true RDWC system.
Thank you for the link, I will check that out!

Ok I saw the drip rings but wasn’t sure about the pebbles. That works great. I have a couple like that from GH called water farms. They are 3 gallon rectangular buckets with drip rings. I went to the 5 gallon bubble buckets for the higher capacity. I just over fill the first week when the roots aren’t longer enough.

I am wondering if those two gals I have growing will take to transplanting. I am worried about that. My hydroguard and pH up will be delivered tomorrow so I’ll have everything together finally and can go through the final steps.
Any suggestions about transplanting?

morning @SmittyJ …I don’t understand the transplanting statement…are you moving to bigger buckets or something?

never mind I read your first post and you are moving from soil to hydro…I have seen some try to clean the roots of the soil but I cannot say if they were successful or not…I personally would not expect this to work out in your particular type of DWC … any particles left could clog your system and it needs to flow to work…

Thank you and yes that was the plan, I didn’t think about the clogging issue, I was concerned about killing the plants with the shock of changing from soil to hydro.

I have done that once. My advice would be to submerge your plants soil with water to help loosen it up. Add an additional airline with an air stone in the bottom of your bucket. I’ve used both the drip loop and air stone in my setup. Extra air to the roots is a good thing. Drop your plant into the net pot without any clay pellets so roots have a better to get to the water. Then add your water nutrient mixture. Then you’ll add the clay pellets on top. It shouldn’t matter too much about clogging your drip loop. Just fill your bucket a little higher such that water level reaches the bottom of the net pot.
You can always toss the water buckets contents in a couple weeks when you do a water change out.
Just be careful to handle the roots with care. The pre soak will help loosen the soil.

Awesome! Thanks for the advice, my setup has an air stone attachment :+1:t2:.
My setup has 4-5 gallon buckets, I’ve only got two setup for now. All of the materials for the solution should be delivered today, I hope to have everything ready for the transfer by tomorrow afternoon. Fingers crossed!

This is what I would do. Take a few cuttings from the larger plant and get them to form roots using clonex


add those to the hydro system once roots have formed.It should take a couple weeks for them to be ready for transfer to your system.

Excellent idea! Yes this makes me feel good, I was just reading on the rapid rooter bag about using them for clippings to clone. I think that is a much better idea. Thank you bro!

I use an Ezcloner which sprays a mist. It runs 24-7 and has 100% success rate. Dip in clonex and use cloning solution in the reservoir.

That’s my method as well. Rock solid aeroponics, I do run a start stop timer but it’s not always necessary. Ezcloner is by far the most friendly system I have used.