@BobbyDigital I feel like I’m doing something wrong here, which is entirely probable.
Plugged meter to outlet. Disconnected the board, so I have only the driver plugged into meter, set to watts. Adjusting to I, there is no fluctuation. Any ideas? Reset the meter, tried again, same.
Leave the board plugged in, that’s what drawing the watts. I meant to only plug in that light, not a power strip with the other light and fans and stuff.
I did ok with 100° outside, and it’s just going to get cooler in that room.
So, I’m just leaving the light plugged to the meter. Since I can’t really gauge actual percentage levels, I’ll have to use the wattage to gauge what to set the light at when I start vegging? Or should it be good to just adjust height?