Single plant rdwc

As I’m getting to the end of my first soil grow I’m starting to scratch the surface of going hydro. I’m looking to go rdwc for the next go round and maybe a soil grow in another room for backup.

My question is; is there anyone that does a single plant rdwc or do you just do dwc? I do plan on SCROGing and my concern with dwc is being able to replace the reservoir water. With a rdwc, I’ll be able to pump the water out and refill it without having to disturb the plant. And also it seems like it’d be way easier to keep up with water levels with a separate reservoir.

Final question, how do you check your roots with a SROGed plant in rdwc/dwc setups?

Check out @Grandaddy013 ‘s grows. he will show you how it’s done. @boardsbird does 1 plant 4x4 grows also

3 Likes

If you net them they’ll need rdwc. Better for keeping the plant happy with the perfect PH/PMM that it wants
Roots go bye bye and are never seen after you net them

2 Likes

Being a soil grower looking from the outside I’ve also pondered this. It sure seems like the recirculating crowd moved from dwc or avoided it for some of the exact reasons you mentioned.

2 Likes

I put a drain on it for water changes

8 Likes

I’ll be on a much smaller scale (5 gal) so I’ll be able to pump it out. Also debating valves on each 5gal bucket (both reservoir side and plant side) and unions on the reservoir side so that I can shut off water and disconnect the old water bucket and install the fresh water bucket. And of course quick disconnects for the air stone lines in the reservoir.

1 Like


Turn one valve off then the other on to drain
Added another airstone but through to much water on lid so now I have 1 large stone in each laying on its side
Make your drains bigger than mine. my pumps can overwhelm my drains

3 Likes

Is there a time window for how long the plant can be without water?

Like when you drain them or forgetting the keep res full?

When you drain

Hours. the plants roots wont dry out very fast in the pot.and they like the air

1 Like

You are correct! You will find life to be way easier based on these things alone…

Now, if you do go with a single bucket system make sure either that part of the lid opens to allow reservoir access like this lid

20190301_165024

Think kitty litter type buckets

Or just have extra buckets in general, that way you can just put the plant in an empty bucket while you do a reservoir change.

4 Likes

It seems as going rdwc would make life much easier. But I’m not seeing any setups anywhere with someone running just one plant rdwc. I don’t know if there’s a reason for that. I’m assuming I can just eliminate all of the other buckets in the system and maybe run the water pump less often?

1 Like

Ask and ye shall receive

4 Likes

That’s what I was looking for, my friend! Thank you. What I can’t really see is how you’re plumbed. Looks like you had a chiller, was that running to your plant bucket or reservoir?

2 Likes

There is a submersible pump in the reservoir that pumps water out of there, to the chiller, then back to the plant bucket.

To interconnect the buckets I used a product called uniseals…

1-1/2" Natural Uniseal (R) Pipe-to-Tank Seal (Pack of 5)

https://www.amazon.com/dp/B00TOONO6U/ref=cm_sw_r_cp_apa_i_PHTECbDDKSVJM

And used this as a guideline

2 Likes

Perfect! Exactly what I was looking for again! Not sure why I couldn’t find it. Thanks again from a fellow Texan!

1 Like

That high times article seems like it’s just a dwc with a reservoir. No pump other than the air pump.

Was this enough flow to recirculate properly? Or did you have another recirculating pump and return lines? I’m getting a water chiller because the only time my house will see 68* is if I forgot to turn the heater on.

It basically is DWC until you take a submersible pump, put it in the “control bucket”, and run a hose from the pump to the “plant bucket”.

I usually run the hose to a barbed 90 like this

20171122_205530

This will try and fill the “plant bucket” with water but the interconnected pipe will then allow drainage or an “undercurrent” back into the “control bucket”.

I basically take my chiller and have the pump move water from the control bucket, to the chiller, then back to the plant bucket

Once the water hits the barbed 90 it shoots back into the plant bucket like this picking up when more oxygen and mixing nutrient solutions very quickly.

20171122_205547

This is the very first, single plant, undercurrent, two bucket system that I ever built

20171122_205521

6 Likes

Yes, you can see in the picture above how fast the water is jetting out

400 GPH Submersible Water Pumps for Aquarium, Tabletop Fountains, Pond, Water Gardens and Hydroponic Systems with Two Nozzles, CE-ROHS Approved, 5.9 ft Power Cord

https://www.amazon.com/dp/B06XKL8XVZ/ref=cm_sw_r_cp_apa_i_tmcFCb2TH9MTK