My PH solution says to add 1ml to a gallon of water. I just googled and it says 1ml is equal to 20 drops of water. I added 4 drops to a watering can that is approximately 30 ml and it lowered my PH from 6.8 down to 4.0. How can I accurately adjust my PH by just 0.1 to 0.2 PH?
I used a 1/4 tsp measuring spoon and let the 4 drops go into the watering can. What could I use that would be more precise. I am assuming that a drop of water is a drop of water whether it falls off a spoon or out of a syringe.
Also since I am not adding nutrients yet do I have to be too concerned with the PH of my water as long as it is in the 6.0 to 7.0 range? Thanks.
I am using the Apera PH20 and it seems accurate. I put it in the calibration solution before I tested and it read 4.0 and 7.0. I notice that when I put it in the watering can it will read 6.5 for example and then the happy face comes on. If I leave the meter in the water for a few more seconds it creeps up to 6.7 or 6.8. Do you go by the first reading once the happy face appears or let it stabilize and trust that reading instead?