1st Grow. Aerogarden Auto Cheese


@peachfuzz

1 Like

@peachfuzz well since I have adjusted my water with ph down I can’t put ph up in the same water correct? So I got some tap water sitting out. I will add that tomorrow and see if I can get the level right. @dbrn32 @peachfuzz . Unless you think I have it dialed in

1 Like

I just storing in the solution in a shout glass when not in use. Not calibrating with that solution @basementstealth

Which solution ru storing it in?

@basementstealth 4.01. Is that correct?

Calibration solution? Not a good idea to store the meter in calibration solution. Get some 3M KCl. That’s storage solution

That looks like 5.0 to me… :wink:
Your plants are so young that I wouldn’t worry about it…
I’m going to be starting from scratch pretty soon… as long as I get the house… we shall see… :wink:
No … don’t go up and down… no good…
Just adjust your ph a little higher then you want,
by a couple of points …
Things will adjust…
Plants are way too small to worry about at this point…
:v::sunglasses:

3 Likes

Good luck @peachfuzz :+1::+1:

1 Like

Week 1 Day 4


@basementstealth @dbrn32 @peachfuzz

2 Likes

So I had my supplemental lights set to on an not timer mode. Hopefully that won’t mess anything up. Past 2 nights when I woke up in the middle of the night I noticed my lights were still on. So last night I shut them off. Maybe about 2 1/2 hours of darkness. The day before the were on all night. @dbrn32 @peachfuzz @basementstealth

1 Like

On my meter my tap water that I had sitting out all night tested at 7.3. Here’s the solution test. Tested tap water just for info to see if meter is close to being dialed in.


@peachfuzz

1 Like

You’re ag has timer built in right, why not just use it?

1 Like

@dbrn32 yea the lights on the Aerogarden are on a timer and that was going off. The ther lights I have in there were set to on and not timer. Just realized the image is a clock for timer.

3 Likes

The ag light should be plenty for right now.

1 Like

@dbrn32 ok. I will shut the others off

2 Likes

Just watch to make sure it doesn’t stretch. If you see that, lower the light.

1 Like

You and this grower are both doing aerogarden grows.

1 Like

@dbrn32 right now my light is at its lowest which is about 7 inches from the top of the plant. Should I raise the light? My plan was to keep it at least 6 inches above the whole time until I switch over to my 135 watt QB. The Aerogarden light I believe is 45 watts.

1 Like

@basementstealth will check him out. Thanks!

1 Like

I would only raise it a little if it’s not showing any vertical growth